Isolated outputs are required for a broad range of DC/DC converter applications and not just the telecom- and datacom-mandated 48V isolation requirements. Isolation can be necessary for ...

The flyback design is a switched-mode power supply (SMPS) that’s been used for 70+ years and still going strong. This supply—also called a power converter—has two distinct operating phases, with power ...

Figure 1 shows the architecture of a conventional isolated flyback converter. These converters can be found frequently in power classes of up to about 60W. A supply voltage is converted to an output ...

Isolated outputs are required for a broad range of DC/DC converter applications — far beyond the well-known telecom and datacom mandated isolation requirements. Isolation can be necessary for noise ...

The choice between a flyback or single-ended primary inductance converter (SEPIC) topology often ends with the designer choosing the most familiar one, but that’s not always the right option, say John ...

This project analyzes MOSFET drain-source voltage spikes and ringing in a flyback DC-DC converter caused by leakage inductance and device capacitances. THe RCD snubber network is implemented and ...

Inductors can be found in many of the devices you use every day, but if you’ve been working only with DC in your projects there’s a good chance you’ve never needed to know anything about them. Now’s ...

One trend that shows no size of ending is the move to smaller personal electronic devices. From smartphones to tablets, each successive generation is smaller and more powerful than the last. It’s ...

Abstract: This paper advocates an inclusive power loss modeling and simulation of rectifier diode of the Flyback power converter working under continuous conduction mode (CCM) and discontinuous ...