In order to sense the solar panel voltage a voltage divider was used to step it down, as it can be greater than the maximum voltage of 5V that the Arduino can handle and thus it can damage the board.

Introduction | This project was created in the scope of the the class ENGR 460 "Power Engineering" conducted through online learning at Walla Walla University. I was tasked with designing, building, ...

As Lifepo4 battery usage is constantly growing, you might want to use it with your solar power installation. Here in this article, I’ll show how to charge the LiFePO4 battery pack with solar power and ...

Have you wondered why a charge controller is so crucial for a solar system installation? Well, that is because it protects the battery bank of a solar energy system from overcharging, which can damage ...

Department of Physics, Semiconductors and Solar Energy Laboratory, Faculty of Science and Technique, Cheikh Anta Diop University, Dakar, Senegal. The work begins with a synoptic diagram of the ...

I think my “MPPT” controller is mistakenly sensing my full 12V AGM as a discharged 24V battery and over-voltage charging it - has anyone seen this happen and know a solution? I bought a new Kings 160W ...