⇒ UART Configuration : One of the most powerful aspects of the TMC2209 is its single-wire UART interface. With UART, you can configure motor current, microstepping resolution, operating modes, and ...

今回は、Arduinoとステッピングモータ（28BYJ-48）を使って、スイッチで回転制御する実験を行ったので、備忘録としてまとめておきます。 Stepperライブラリを使って簡単にステップ数指定で回転 スイッチには INPUT_PULLUP を使うことで、部品数を減らしつつ ...

Arduino ステッピングモーター（複数台可） ステッピングモータードライバ（モーターの数分） スタートボタン用のスイッチ（プルアップ接続）※ ※なくても動作します。スタートボタンが不要な場合は src\stepper-melody\stepper-melody.ino の loop() 関数を修正して ...

A DIY project from a YouTuber presents the latest version of his 7 Segment Clock, v3.2C. This tabletop clock is built using 3D-printed parts and powered by an Arduino ...

It’s fair to say that building electronic gadgets is easier now than it ever has been in the past. With low-cost modular components, there’s often just a couple dozen lines of code and a few jumper ...

Throw some blinking LEDs on a project and it’s bound to make the front page of Hackaday. We do love builds of a more analog character, though, and this analog gauge stepper motor breakout board seems ...

Makers, developers and Arduino enthusiasts searching for silent stepper drivers with high resolution encoders which are also Arduino compatible. May be interested in the new range of uStepper S line ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...